Your Cart: item(s)
Please see the attached file for full problem description.
Subject:
Mechanical and Materials Engineering
Topic:
Mechanical Engineering Design (Industrial)
Posting ID:
20307
OTA ID:
103997
Beam deflection and Stress at corner?
So, how would I set this problem up? We're asked to determine the deflection of a beam location for a 2000N load. However, the force is directed up the corner NOT centroid. In other words, at beam corner up through the side wall. Kind of like a ledge holding a flower pot. Given load=2000N, on the tip of a 1m beam. Beam dimensions are H=80mm B=W=40mm and t=thickness of 1.5mm.
Subject:
Mechanical and Materials Engineering
Topic:
Mechanical Engineering Design (Industrial)
Posting ID:
25278
OTA ID:
103997
1. (20%) (a) Draw a free-body diagram of the system. (b) Find the forces acting on joints A,B & C. (c) Find the resultant A and its direction. Ax = _________ Ay = _________ A = __________ Bx = ___________ By = ___________ Cx = ___________ Cy = ___________
Subject:
Mechanical and Materials Engineering
Topic:
Mechanical Engineering Design (Industrial)
Posting ID:
29497
OTA ID:
104565
5.(20%) The draw bridge BCD weighs 1000 lb. 1000 lbs. Calculate: (a) the tension in the cable AC. (b) Dx and Dy and the resultant, D.
Subject:
Mechanical and Materials Engineering
Topic:
Mechanical Engineering Design (Industrial)
Posting ID:
29498
OTA ID:
104565
Design Engineering (Working Stress; Length:Diameter Ratio)
2) Find the diameter and length of a mild steel end journal on which there is a load of 35 KN (shock loading). Assume a safe working stress of 40 MPa and a lengh:diameter ratio of 1.5
Subject:
Mechanical and Materials Engineering
Topic:
Mechanical Engineering Design (Industrial)
Posting ID:
33104
OTA ID:
104618
Page generated in 0.0116 seconds