APT Programming (Geometry and Motion Statements)

Write the APT geometry and motion statements for the work-part in the figure below {see attachment}. Assume the machine starts at P0 and moves around the work-piece in an anti-clockwise direction. (P0 = POINT/ 10,-20,0)

APT Programming (Geometry and Motion Statements)

Write the APT geometry and motion statements for the work-part in the figure below {see attachment}. Assume the machine starts at P0 and moves around the work-piece in an anti-clockwise direction. (P0 = POINT/ 10,-20,0)

NC PART PROGRAM + APT PROGRAM

AFTER YOU HAVE COMPLETED THE NC PART PROGRAM , THEN PLEASE COMPLETE THE APT PROGRAM FOR THIS PART .

nc part program

Explain the difference between the following parts of nc programs: (a) N001 G01 G41 X005 Y017 EOB N002 EOB (b) N001 G41 E0B N002 G01 X005 Y017 EOB

NC PROGRAMMING

CREATE AN NC PART PROGRAM FOR MAKING THE SLOT SHOWN IN THE ATTACHMENT.THE CUTTER DIAMETER IS 3/16 INCH. THE STARTING POINT IS (0,0) AT 2INCHES TO THE LEFT AND 2 INCHES BELOW THE LOWER LEFT CORNER OF THE PART. THERE IS ALSO AN EXAMPLE WITH A FULLY WORKED OUT SOLN INCLUDED IN THE ATTACHMENTS. WRITE ALSO THE APT GEOMETRY AND MOTION STATEMENTS FOR THE WORK PART SHOWN. THE OTHER DOCUMENT IS AN ATTEMPTED SOLN. YOU WILL HAVE TO MODIFY IT FOR ME TO OBTAIN THE NC PART PROGRAM SOLN.